Cat's paw (knot): Difference between revisions

From ScoutWiki, For Everyone, Everywhere involved with Scouting and Guiding...
Jump to navigation Jump to search
m (1 revision(s))
m (This article was propably imported from Wikipedia, http://en.wikipedia.org/wiki/{{PAGENAME}})
Line 1: Line 1:
{{ThisPageWasImported}}
{{Knot-details
{{Knot-details
| name=Cat's paw
| name=Cat's paw

Revision as of 22:11, 30 March 2007

Cat's paw
Category hitch
Origin Ancient
Related girth hitch, lark's foot, cow hitch
Releasing Non-jamming
Typical use Attaching a rope to a hook or ring
ABoK #1891


The Cat's paw is a knot used for connecting a rope to an object. It is is very similar to the cow hitch except there is an additional turn on each side of the bight, making it less prone to slipping.

Uses

  • Attaching a rope to a hook (or to a post or rail where the load is perpendicular to the post) with more security than a simple girth hitch.
  • Joining an eye to a ring.
  • Strongly joining eyes in the ends of two lines, where there is access to the end of at least one line.

Comments

In one method of tying, it can be pre-formed in the middle of the rope, then slid over the end of a post or rail.

In an alternative method, a line with an accessible end and an eye can be attached to another eye, ring or rail with inaccessible ends.

The knot balances the load between the two hitches, and is used in wharfs and docks. If one hitch fails, the other hitch should hold until the load can be safely and swiftly lowered to the ground.

Structure

Formed from a bight turned up over itself (like a girth hitch) but with an extra turn on each side. In variations, there may be multiple extra turns.

Tying

Method 1

Form a bight in the middle of the line, and pull it back over itself like a girth hitch. This forms two loops, turned in opposite directions. Give each loop one more full turn in the direction that will tend to tighten it (the wrong direction will undo the loop completely). Pass both loops over the hook, rail or post and pull tight, taking care to push the bight up snugly against the turns.

Method 2

If working end of the line has an eye in it, and the standing end is accessible, the knot can be tied to a closed ring, another eye, or a rail with inaccessible ends, as follows. Pass the eye around the ring or rail, then pass the standing end through its own eye (this effectively forms a girth hitch). Then pass the standing end through the eye again, and pull up tight, taking care to push the bight up snugly against the turns.

When using the cat's paw to join two eyes, this process may be repeated several times to give several turns - as many as five in a fine fishing monofilament. Then when tightened, instead of pulling the bight up against the turns, both eyes are pulled equally, to make neat coils of turns in both eyes, meeting halfway between them.

External link