Sailmaker's whipping
| Sailmaker's whipping | |
|---|---|
| Category | whipping |
| Related | West Country whipping |
| Typical use | Whipping |
| ABoK | #3446 |
The Sailmaker's Whipping is the yardstick against which other whippings should be compared. It is the most durable because the wrapping turns are wrapped with frapping turns which are threaded through the rope. However, it requires a needle and is relatively hard to understand and remember.
Technique
The twine is first threaded diagonally through the rope. The twine is then wrapped round the rope including the diagonally threaded end. A needle is then used to thread the two ends through the rope to enclose the wrapping turns. Finally a reef (square) or a string of reef (square) knots is tied. Then this string of reef (square) knots is pulled through the rope to bury the ends.
Alternatives
The West country whipping is a quick practical method of using twine to secure the end of a rope to prevent it fraying. Half hitches are tied alternately behind and in front of the rope until the width of the band of twine approaches the diameter of the rope. It has several advantages: it can be tied without a needle; it is simple to understand and remember; if the whipping fails, the loose ends can usually be re-tied to temporarily prevent the rope's end from fraying.
Burning the Rope's End: The end of many synthetic ropes can be melted using heat, e.g., a flame. While this is simple and quick, it tends to fail in ropes subject to heavy use. Ideally a rope's end should be both melted (if applicable) and whipped.